Page Comparison

Overview

This page outlines the steps needed to setup set up a Zebra Bluetooth Scanner on for instance a Zebra ET50.

...

Before Update:

After Update:

2. Connect Scanner to Tablet

The datawedge only has support for a direct bluetooth Bluetooth connection from the Scan handle. Even though there is a USB connection this is not supported by the data wedge.

...

1. If it is already connected, remove the bluetooth Bluetooth connection from the connected bluetooth Bluetooth devices in Android by going into Bluetooth and in the list finding and device and clicking on Forget
2. Open the parring utility app on the Zebra Scanner (pre-installed). This will connect the scanner to the android device.  if the device does not connect when scanning the barcode the use the factory reset barcode in the Appendix section (bottom of this page).
3. Make sure in the ScanParams in the data wedge that the Code Id Type is set to Aim (like always)
   TODO: AddScreenshot
   1. Go into Datawedge App
   2. Click on MobileWMS profile
   3. Click Configure Scanner Settings
   4. Click Scan Params
   5. Verify that Code Id Type = Aim
      

Appendix

Factory reset:

Manual:

If the scanner disconnects every time it gets in the cradle:

https://www.zebra.com/us/en/support-downloads/knowledge-articles/evm/DS3678-Unpairs-when-Placed-in-Cradle.html

Image Added