1. Prerequsites
To use the ProGlove the Connect App must be installed, this is done by Tasklet Factory as part of the installation.
Tasklet Factory will also add the ProGlove App to the Lockdown screen of your devices, which should look like this after these changes:
Should your not see that app on your device, then please raise a ticket to get it implemented.
2. Connect To a Device
Start the ProGlove App and connect the device using that app.
It might be that you initially needs to perform a small setup of the ProGlove app, make sure to select SDK as Integration Paths - see below:
Also, make sure that the Connect app is set up to "Send current buffer to the SDK output". This can be verified in the Rules menu item, by selecting the Send To SDK rule.
3. Configuration changes on the device
It is possible to configure various settings on the device, for instance to change the timeout for the MARK 2 scanner to disconnect.
This is done using a barcode that are created by accessing http://config.proglove.de.
To configure the reading of GS1 Data Matrix, a separate configuration must be scanned;