Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 9 Next »

The RS5100 Bluetooth ringscanner is unfortunately not supported by Zebra's pairing software.
In order to make the RS5100 scanner pair with a Zebra device, the following procedure need to be done, which makes it appear as a RS6000.

1. Perform Clean Boot 

  1. Clean boot the device by pressing the Restore Key until the white light appears.
  2. Release the Restore Key, and immediately press it again.
  3. Continue to hold the key down until two beeps indicating a clean boot are heard, and the scanner boot beep sequence is heard.
    This sets the RS5100 back to it's factory configuration.


2. Configure the Scanner

After resettings the scanner. Scan the following barcode, to make the RS5100 mimic an RS6000.

3. Reboot the scanner by holding the Restore Key down for three seconds, and releasing it.

4. Reboot the device.

5. Finally Pair the Device Using the Pairing app on the device.

6. On the device the RS5100 is connected now to, open the DataWegde app and select the Mobile WMS profile, Go to: Scanner configuration --> scan params --> Code Id Type --> This must be set to "Aim".



  • No labels