Setting Up Zebra Bluetooth RS5100 Ringscanner

The RS5100 Bluetooth ringscanner is unfortunately not supported by Zebra's pairing software.
In order to make the RS5100 scanner pair with a Zebra device, the following procedure need to be done, which makes it appear as a RS6000.

1. Perform Clean Boot 

1. Clean boot the device by pressing the Restore Key until the white light appears.
2. Release the Restore Key, and immediately press it again.
3. Continue to hold the key down until two beeps indicating a clean boot are heard, and the scanner boot beep sequence is heard.
   This sets the RS5100 back to it's factory configuration.

2. Configure the Scanner

After resettings the scanner. Scan the following barcode, to make the RS5100 mimic an RS6000.

3. Reboot the scanner by holding the Restore Key down for three seconds, and releasing it.

4. Reboot the device.

5. Finally Pair the Device Using the Pairing app on the device.