Overview
| Table of Contents | ||
|---|---|---|
|
1.
...
Prerequisites
To use the ProGlove the Connect App must be installed, this is done by Tasklet Factory as part of the installation.
...
Should your not see that app on your device, then please raise a ticket to get it implemented.
2. Connect To a Device
Start the ProGlove App and connect the device using that app.
It might be that you initially needs need to perform a small setup of setup of the ProGlove app, make sure to select SDK as Integration Paths - see below:
...
Also, make sure that the Connect app is set up to "Send current buffer to the SDK output". This can be verified in the Rules menu item, by selecting the Send To SDK rule.
3. Configuration changes on the device
It is possible to configure various settings on the device, for instance, to change the change the timeout for the MARK 2 scanner to disconnect.
This is done using a barcode a barcode that are is created by accessing accessing http://config.proglove.de.
To configure the reading of GS1 Data Matrix
4. Configuration of GS1 DataMatrix
To enable GS1 DataMatrix on the ProGlove, the Firmware Version must be minimum 1.3.0.
Click the burger-icon and select "Update firmware.."
Select "Use 1.3.0 Firmware" and then "Update the current device"
When update is complete, a separate configuration must be scanned;
| View file | ||||
|---|---|---|---|---|
|
NOTE: When scanning the "Enable GS1 Data Matrix reading" barcode, the ProGlove will not give a confirmation beep or flash. Instead, it will stop scanning the code as a confirmation, meaning that the laser light will just go out when it has a correct read.