Page Comparison

...

The Bluetooth ringscanner is unfortunately not supported by Zebra's pairing software.
In order to make the ringscanner pair with a Zebra device, the following procedure needs to be done.

...

If you are still experiencing an issue then please update the build version on your mobile/tablet device (Make sure to check the android version on your device).

4.

...

Once the ringscanner can connect to your device

1. Reboot the scanner by holding the Restore Key down for three seconds, and releasing it.
2. Reboot the device.
3. Finally Pair the Device Using the Pairing app on the device.
4. On Once the device the ringscanner RS5100 is connected now to open the DataWedge app and select
   1. Select the Mobile WMS profile
   ,
   2. Go to:
   Scanner configuration -> scan params ->
   1. Configure scanner settings
   2. Select Scan params
   3. Select Code Id Type
   ->
   1. 1. This must be set to "Aim".